SATA Cable for Connecting DB20 Drives to MTC Series

SATA cable for connecting DB20 drives to U-Reach MTC series duplicators. Duplication cables are a consumable part of any busy copy or sanitization bench: connectors wear with repeated drive swaps, and a single marginal cable can cause read errors, failed verifies or dropped drives mid-run. Keeping known-good replacements on hand keeps your throughput steady and your copy-and-verify results reliable

Interface (device side)
Male 60 pin connector designed to connect to Molex P/N 0709282001 found on DB20 SATA drives.

Interface (duplicator side)
Female 7-pin SATA data cable for data transfer and 4-pin power for 12V and 5V power requirements.

Dimensions (excluding cables)
2.25x 1.75 x0.75 in

Cable Length
8 in (SATA data), 7 in (power)

Match the cable to your duplicator series.

Match the cable to your duplicator series before ordering. If you're not certain which cable your machine uses, send us the model and we'll confirm. See our full range of Duplicator Cables, or contact us to confirm the right cable for your bench.